Fusion360 Post Processor For EZPath Control

[Dan]

I have created and maintain a post processor for EZPath lathes.

This post works, but always double check your output and run on low feed overrides to ensure safe operation of your equipment.

This post was created to assist people wanting to use modern software to program their lathes.

It is offered for use with no guarantees, no warranties, and is to be used at your own risk.

Please read the included document which outlines how to get the best results from this post processor on your machine.

This topic is locked, the only updates to this thread will be updates to the Post Processor as Fusion receives updated and bugs are discovered in the post. Please subscribe to this thread in order to receive email notifications of potentially important updates to the post processor.

Updates:
12/28/2025 - Current Version is V6
01/17/2026 - Current Version is V7

[Dan]

Update to V7